During the µWell incubator WW Z mapping, the value intermittently drops to zero.
µWell tool not correctly seated
WW Z motor loosing steps
WW head level sense not working correctly
Movement of the WW Z shaft impeded
The system posted a condition code MF0-200. The sensor is working. The pump does not move. What is the possible cause ?
No power on the reagent metering arm
Proboscis is unscrewed
Fuse is blown on the Reagent metering DSP board
All of the above
Which of the following options is wrong about MOD74:
Type A MOD
Need to format and re-load software.
Depending on the current system configuration, the required accessories may vary.
Need Dual Boot USB tool of MOD67 and above.
According to TC2022-298，which should be done after Pipetteing Tip replaced?
Antivirus Scanning
Daily Maintanence
Monthly Maintanence
Yearly Maintanence